Indian Brand Wall Putty

<p><b xss="removed"><i><u>Preparation of wall filler paste</u></i></b></p> <p>&nbsp;</p> <p class="MsoNormal" xss="removed">&nbsp;</p> <p class="MsoNormal" xss="removed"><o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Take the required amount of wall filler into a pan. To prepare a paste with a good consistency, you will need 35-40% water by volume.</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Mix in half of the required amount of water. Knead/mix the putty and wait a few minutes. </span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Mix in the remaining amount of water to obtain the desired consistency. </span> <o></o></p> <p class="MsoNormal" xss="removed">&nbsp;<span xss="removed">Mix vigorously for 5-10 minutes to obtain a uniform paste without lumps. </span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Mix only the amount of product that will be used within 2 hours of preparation. </span> <o></o></p> <p class="MsoNormal" xss="removed">Mixing can be done manually or using a suitable electric mixer.</span></p> <p class="MsoNormal" xss="removed">&nbsp;</p> <p class="MsoNormal" xss="removed"><o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed"><b><i><u>Application of wall filler</u></i></b></span></p> <p class="MsoNormal" xss="removed">&nbsp;</p> <p class="MsoNormal" xss="removed"><o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Ensure that the surface is completely clean</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Ensure that the surface is plastered or made of cementitious material.</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">The surface must be moderately rough and wet. </span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Apply the first coat of Wall Putty (1.5 mm thick) using a trowel/spatula on the wall with a "bottom-up" configuration. </span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Apply the second coat of Wall Putty (1.0 mm thick) preferably after 4 hours in summer and after 12 hours in winter. The second coat should be applied "horizontally" to even out any marks left by the application of the first coat, if present.</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Remove the putty again after 1 minute if left undisturbed for 30 minutes. </span> <o></o></p> <p>&nbsp;</p> <p class="MsoNormal" xss="removed"><span xss="removed">Allow to dry completely for 3 days and then use fine sandpaper to remove any application marks, if present. </span></p> <p class="MsoNormal" xss="removed"><o></o></p> <table border="0" cellpadding="0" cellspacing="0" width="437" xss="removed"> </table> <p>&nbsp;</p>