Product Description
<p><b xss="removed"><i><u>Preparing the paste for filling</u></i></b></p> <p> </p> <p class="MsoNormal" xss="removed"> </p> <p class="MsoNormal" xss="removed"><o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Take the required amount of putty in a saucepan. To make a paste with a good consistency, you need 35-40% water by volume. </span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Mix in half the required amount of water. Knead/mix the putty and wait a few minutes. </span> <o></o></p> <p class="MsoNormal" xss="removed"> <span xss="removed">Mix in the remaining amount of water to achieve the desired consistency.</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Stir vigorously for 5-10 minutes to obtain a smooth paste without lumps.</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Mix only as much product as can be used within 2 hours of preparation.</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Mixing can be done by hand or with a suitable electric mixer.</p> <p class="MsoNormal" xss="removed"><o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed"><b><i><u>Application of Wall Putty</u></i></b></span></p> <p class="MsoNormal" xss="removed"> </p> <p class="MsoNormal" xss="removed"><o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Ensure that the surface is completely clean</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Ensure that the surface is plastered or made of a binding material.</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">The surface should be moderately rough and wet.</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Apply the first coat of filler (1.5 mm thick) with a blade/spatula to the wall in a "bottom-up" configuration.</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Apply the second coat of filler (1.0 mm thick), preferably after 4 hours in summer and 12 hours in winter. The second layer should be applied "horizontally" to even out any marks left by the first layer, if any.</span> <o></o></p> <p class="MsoNormal" xss="removed"><span xss="removed">Remove the filler paste again for 1 minute if it has not been touched for 30 minutes.</span> <o></o></p> <p> </p> <p class="MsoNormal" xss="removed"><span xss="removed">Allow to dry completely for 3 days, then use fine sandpaper to remove any application marks, if any.</span></p> <p class="MsoNormal" xss="removed"><o></o></p> <table border="0" cellpadding="0" cellspacing="0" width="437" xss="removed"> </table> <p> </p>
